Central Flying Academy Flight Controls Check
Why You Need A Flight Controls Check Before Every Flight
The Cessna 172 started its takeoff roll, but just a few seconds in, the pilot knew he had a problem.
He tried aborting the takeoff, but just seconds later in a light crosswind, he departed the right side of the runway. The aircraft went through the grass, and eventually into a group of trees.
Fortunately, the pilot only had minor injuries, but the same couldn't be said about the plane he was flying.
Here's the NTSB's analysis:
The pilot reported that during the takeoff roll, he tried to abort the takeoff because he had not removed the bolt he had placed in the yoke for a gust lock. He reported that the crosswind pushed the airplane off the right side of the runway into the grass, the airplane impacted trees, and sustained substantial damage to both wings and the empennage. The pilot reported that the accident was due to him not removing the bolt in the yoke.
The pilot reported no pre-impact mechanical failures or malfunctions with the airframe or engine that would have precluded normal operation.
Non-Standard Gust Lock
In most Cessna single-engine aircraft, the gust lock is connected to the control wheel, and it protects the flight controls from fluttering during high winds on the ground.
A metal flag covers part of the ignition switch, making it hard, if not impossible, to start the airplane when the gust lock is installed.
Unfortunately in this accident, the pilot was using a bolt to gust lock the controls, and there wasn't a plate to prevent the aircraft from starting before the bolt was removed. But the solution was simple: a flight controls check before takeoff would have prevented the accident from ever happening.
It doesn't matter what you fly, whether it's a Cessna 172 or Boeing 777. During one of your pre-takeoff checklists, there's going to be a flight controls check.
Depending on your aircraft, the flight controls check might be listed in pre-flight, run-up, just before takeoff, or within multiple checklists. And when you get to it, here's what you should be looking for:
- Check free and correct motion (flight controls are moving up, down, left, and right as they should).
- Make sure no unusual force is needed for movement (this means either abnormal pressure or looseness).
- Is the autopilot disengaging correctly, and are there any malfunctions?
- Listen for unusual sounds from cables, linkages, and pulleys.
- Make sure no foreign object debris could jam your controls, both outside the plane and in the cockpit.
A Simple Solution: Follow The Checklist
Procedures can make all the difference in the outcome of a flight. It seems obvious, but follow your checklist through every step, and get in the habit of checking your flight controls thoroughly before you taxi on to the runway.
After all, they're the last things you want to fail when you're in the takeoff roll.
This is not an original article. It first appeared on boldmethod.com on 3 June 2017. To read the original article click here.
If you dream of becoming a commercial pilot or private pilot, and you are planning on joining a flying school in Johannesburg Gauteng, or anywhere is South Africa, then come to Central Flying Academy for your introductory flight and take a tour of our facilities. We focus on pilot safety, both in ground school and flight training. Contact us for more information